80 PLUS Verification and Testing Report
INPUT SPECIFICATIONS
Input voltage:
90 to 264 VAC
Input frequency:
47 to 63 Hz
PROTECTIONS
Over voltage protection: +3.3V: 3.5V - 4.8V;
+5V: 5.5V - 6.82V;
+12V: 13.4V - 15.6V
Short circuit protection: It is defined to be a short circuit load of less than 0.1 ohm
GENERAL SPECIFICATIONS
Hold-up time: >17ms
Efficiency: >80% at full load.
Voltage: 1500VAC from input to output
MTBF: 100,000 hours
ENVIRONMENTAL SPECIFICATIONS
Operating temperature: 0˚C to +50˚C
Storage temperature:
-20˚C to +80˚C
Relative humidity:
95% non-condensing
DC Output:
| OUTPUT VOLTAGE |
OUTPUT CURRENT |
REGULATION |
OUTPUT |
| MIN ( A ) |
MIN ( A ) |
LOAD |
LINE |
RIPPLE & NOISE
MAX. [P-P] |
| +5V |
0.5 |
20 |
±5% |
±1% |
50mV |
| +12V1 |
1.5 |
16 |
±5% |
±1% |
120mV |
| +12V2 |
1.5 |
16 |
±5% |
±1% |
120mV |
| -12V |
0 |
0.5 |
±10% |
±1% |
120mV |
| +3.3V |
0.5 |
20 |
±5% |
±1% |
50mV |
| +5VSB |
0 |
2.5 |
±5% |
±1% |
50mV |
(1) The +3.3V and +5V total output shall not exceed 150watts.
(2) total output for this subject
power supply is 400 watts.
(3) Ripply and noise measurements shall be made under all specified load conditions through a single pole low pass filter with 20MHz cutoff frequency. Outputs shall bypassed at the connector with a 0.1uF ceramic disk capacitor and a 10uF electrolytic capacitor to simulate system loading.
(4) -5V is option.
80+ High Efficiency
