dynapowerusa Design to Protect Technology
Products Search
    
 
 
 
Left_CSS









 
PS2 500W Power Supply
 
Input Characteristics
> Input Range: ±10% of 115Vrms/57~63Hz or 230Vrms/47~53Hz,
> Manual Selection
> Input Current: 8.5A (RMS) @115Vac, 5A (RMS) @230Vac
> Inrush Current: No Damage
• Temperature Range: Operating: 0°C ~ +50°C, Full load at 25°C, De-rate 2W/°C from 25°C to 50°C;
• Storage & shipping: -20°C ~ +65°C
• Humidity: 5 ~ 95% on operating and storage
• Dielectric Withstand: Primary frame ground 1800V AC for 1 second
• Efficiency: 70% minimum measured at normal AC mains voltage and frequency with full load
• Rise time: Less than 20ms
• Hold-up Time: 17ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA
• MTBF: 100,000 hours
• Dimensions (LxWxH): 140x150x86mm/5.5x5.9x3.4inch
• Complied with ATX12V standard
• High efficiency and reliability, low noise and ripple
• Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).
• Remote ON/OFF function
• Internal 12V DC fan included
• Noise Killer (thermal fan speed control function)
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Complies with FCC part 15 subpart J class B 115Vac operation,and CISPR 22 class B at 230Vac operation
• Approved by UL60950, CSA C22.2 NO.60950, TUV EN60950 or VDE EN60950,NEMKO EN60950 (CB Report)

V1 +5V ±3% 0.3A 16A 50mV
V2 +12V1 ±3% 1A 15A 120mV
V3 +12V2 ±3% 1A 16A 120mV
V4 +3.3V ±3% 0.5A 22A 50mV
V5 -12V ±5% 0A 0.8A 120mV
V6 +5VSB ±5% 0A 2.5A 50mV
 
       Site Map   |   Terms of Use   |   New Account   |   RMA